Geekvape Aegis Mini Kit Review

Today we will talk about the well-known company GeekVape and its new brainchild – Aegis Mini Kit. This starter kit is the younger brother of GeekVape Aegis , which over the year gained an audience of over one hundred thousand people. The Aegis Mini Kit is compact in a rugged case with a built-in battery. Well, let’s go!

vidnamod

Information for information

This starter kit has as many as 17 different colors, as well as two versions of the configuration – the standard and TPD version (Tobacco Products Directive – a European directive prohibiting the volume of liquid in an electronic cigarette from above 2 ml). Sold as a separate mod and starter kit with a Cerberus atomizer. The mod is equipped with the modes varivatt, thermocontrol, bypass, TCR, VPC, has a built-in 1800 mAh battery, landing up to 28 mm and stealth format.

Electronic Cigarettes Wholesale,Vape Wholesale and Distribution – Ave40

upakovka

you like

there is a hologram in the bottom corner that protects it from a fake

cvetamoda

Equipment

– Mod Aegis Mini; 
– A Cerberus tank with 5.5 ml expanded Bubble Glass and a pre-installed Super Mesh X2 evaporator with a resistance of 0.3 Ohms 
– Spare evaporator Super Mesh X2 with a resistance of 0.3 Ohms, which is sealed in vacuum; 
– Replacement glass for 4 ml; 
– USB cable for charging and firmware; 
– Instructions for use; 
– Replaceable seals for mini-USB port; 
– A set of o-rings and sealing rings for the tank.

vidnabora

Technical parameters:
Power: from 5 to 80 W 
Supported resistance: from 0.05 to 3 Ohm 
Modes: varivatt, Ni200, Ti, stainless steel, temperature coefficient, mechanical mode, variable power control mode. 
Temperature limits: 100-315 degrees Celsius, 200-600 degrees Fahrenheit.

Instruction (extract)

manual

manualcik

Cerberus tank overview

Now we estimate the atom Cerberus itself. Previously, we were already familiar with this tank when unpacking GeekVape Nova , where we stopped at its consideration in more detail.

Here we will quickly run. Drip-type 810th, sits quite tight, but has a non-standard look, there is a small chamfer at the junction with the top cap.

Top Vape Tanks, Vape Atomizer, Clearomizer Online | Ave40

bakrassmotrim

At the same time, their favorite 810 drip types are installed without problems and the barrel of fun starts to look, for example, as shown in the figure below.

vidsdriptipom

sdripomm

The top one is not as comfortable as the SMOK products, but this is not fatal – there are no threads here, the top cap comes with a snap in a half turn, which is also normal. Approximately the same implementation of refueling in Zeus X RTA . There is a silicone gasket for reliable sealing. The only thing that bothers is that it’s a flat refueling area, which, after filling up with liquid, will have to wipe off the excess zizhka with a napkin.

vrazbore

Dimensions:
Height: 42.5 mm; 
Landing diameter: 25 mm; 
Volume: 2/4 / 5.5 ml depending on the glass.

vrazboretank

The mine is very wide with a conical treatment. Extended glass looks stylish and is easily replaced.

The evaporator is wide and goes on a mesh, on the evaporator itself it is indicated that it is recommended to hover at 30-40 watts.

Scoil

Taste quite good. The base sits tight and has airflow adjustment with a stopper. Bottom is not very well protruding pin, so it is not recommended to use the tank on mehmodov.

Fashion review

The connector on this mod is very wide with a giant landing. 510 pins are not very buried when you wind some drips or atomizers, so levitation is obtained a little.

vidpina

However, the tank Cerberus sits flush. I also want to say about the thread on the 510-m connector, it is tight and the tanks are twisted with a little effort, this is good.

atomnabake

On this baby, you can probably wind up all up to 28 mm. Here’s what a 24mm drip looks like – Drop Dead RDA from the guys from HellVape.

srdamod

And here is how the 25mm mm rip is the Warrior RDA .

modsr

With atomizers, too, everything looks valid. Here’s how with Serpent Elevate RTA from Wotofo. This tank is 24 mm on the seat and visible levitation.

sbakom

Feedback from use

What can I add about this mod? It is perfect for fans of stealth devices, any MTL-tank will perfectly fit on it and you will get compactness and excellent taste in an almost unkillable shell. Why practically? We still do not recommend to drop this device on the screen, since you most likely will get a crack. He will continue to work, but the appearance will be spoiled.

viddvruke

The experience of using this mod is definitely positive. There are small flaws, such as the appearance tampered with a connector on small tanks, as well as a small amount of battery (Western sources say that instead of the stated 2200 modes, it has only 1800 mAh). But speaking in general, this is a worthy player in the market of electronic cigarettes, with a high-quality assembly and a rich bundle, which was once again taken care of by engineers from Gikveypa. If short-fry fries on varvatte, bypass seems that even faster. They didn’t bother with thermal control, as they are of no particular interest.

In general, such a class of wipes, with protection from moisture and dust, as well as from impacts, has a right to exist, since there is a whole army of fans following adventure and active recreation. At the end of 2018, we talked about an interesting mod – the Wismec Active vape column , which, although a little, found its admirers.

Vape Starter Kit, Wholesale E Cig Starter Kits – AVE40

GeekVape Aegis mini 80W can be safely called a good solution for lovers of compact solutions, while for the price-quality ratio you can safely put a rating of 5, since this device has all the necessary options offered by the manufacturer.

Cons and pros:

Minuses:

– poor screen protection with a universal “body armor”;

– small battery capacity;

– cover soft-touch mod, will require care, because dust literally sticks to it;

– there is no reset button for resetting the settings, if anything goes wrong.

Pros:

– compactness;

– great design;

– readable screen;

– Rich equipment;

– moisture, dust and shock resistant casing;

– quality tank included;

– there is the possibility of fast charging on a 2-ampere cable (up to 80% per half hour)

– a variety of body colors;

– good build quality.

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available: Geekvape Aegis Mini Kit
Hot Sale Recommendation:

Vaporesso Aurora Play Zippo Pod Starter Kit

Vaporesso Luxe 220W TC Kit

Geekvape Aegis Legend 200W with Alpha Tank

Voopoo Drag Nano Kit

OUMIER Armadillo RDA

Vape Wholesale & buy Electronic Cigarettes online in Bulk. Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html

Teslacigs XT 220W Kit Review

Instructions for boxing mod Tesla XT 220W with tank Tallica Mini

Please read the user manual carefully before using it. We are not responsible for any intentional damage or improper use of the device.

For more information or questions regarding the use of products, please contact us through the website www.ave40.com.

Instructions for boxing mod Tesla XT 220W with tank Tallica Mini

Specifications

Box mod

  • Dimensions: 92 x 62.5 x 30 mm;
  • Material: zinc alloy;
  • Battery type: two 18650/20700/21700 high-current batteries (the discharge current must be higher than 40 A);
  • Weight: 258 g;
  • Output mode: Kant (varvatt) / TC-SS316 / TC-Ni200 / TC-Ti / TCR;
  • Output power: 7–220 W (in increments of 0.5 W);
  • Max. output voltage: 7.5 V;
  • Max. output current: 50 A;
  • USB: 5 V / 1.5 A;
  • RGB LED backlight mode: LED M1 / ​​LED M2 / LED M3 / Blue M4 / Red M5 / Green M6 / Purple M7;
  • Taste mode: Normal / Soft / Hard / Custom;
  • Memory mode: M1 / ​​M2 / M3;
  • Resistance range in mode: 0.1-3.0 ohm;
  • Resistance range in TC mode: 0.05 – 1.0 Ohm;
  • Temperature range: 100-300ºС / 200-600ºF.

Clearomizer

  • Dimensions: 25 x 50 mm;
  • Material: stainless steel + aluminum alloy;
  • Capacity: 4 ml (ordinary glass tube) / 6 ml (glass bubble flask);
  • Resistance range: TS-XX evaporator 0.18 ohm (60 – 110 W).
Instructions for boxing mod Tesla XT 220W with tank Tallica Mini. Kliromayzer

Using

Power up

Press the bottom cover and insert two high-current 18650/20700/21700 batteries into the device case, turn the switch to the “On” position and the device will turn on, the “TESLACIGS” logo will appear on the screen.

Vape Starter Kit, Wholesale E Cig Starter Kits – AVE40

Note

Before operating, please adjust the power to the range corresponding to the atomizer used.

Power off

Turn the switch to the “Off” position and the device will immediately turn off.

Soaring

To hover, press and hold the main button. Release the main button to stop hovering.

Power lock / unlock

In variable mode, press and hold simultaneously the main button and the down button to lock / unlock the device power.

Lock / Unlock Temperature

In TC / TCR mode, press and hold simultaneously the main button and the down button to lock / unlock the temperature.

RGB LED backlight mode

When the device is turned on, press the main button and the Up button to switch to the RGB LED backlight mode. Then press the Up / Down buttons to switch between blinking or turning off the backlight.

Stylish LED RGB backlight (blue, red, green and purple) provides aesthetic pleasure.

Vape Wholesale Supply,Vape Wholesale China – AVE40

Power adjustment

When the device is on, press the Up / Down button to adjust the power accordingly. Power is adjustable in increments of 0.5 watts.

Press and hold the Up or Down button to quickly adjust power.

Determination of the resistance of the spiral

When you connect a new atomizer or reconnect an existing atomizer, the device will prompt you for confirmation.

If you connected a new atomizer, then click the “Up” button. If you reconnect the same atomizer, then press the “Down” button.

Atomizer refill

To fill with liquid, unscrew the top cover counterclockwise, then pour the liquid directly into the slot.

Note

  • When using a new evaporator, fill the tank and let it stand 5 minutes before use so that the cotton is soaked with liquid.
  • During tank filling the airflow must be completely closed.
  • When the tank is full of liquid, do not leave the top cover open longer than when refilling.
Instructions for boxing mod Tesla XT 220W with Tallica Mini tank. Atomizer refilling

Evaporator replacement

Unscrew the clearomizer base counterclockwise, remove the old evaporator and replace it with a new one.

Instructions for boxing mod Tesla XT 220W with Tallica Mini tank. Replacing the evaporator

Air flow adjustment

Turn the ring to the bottom of the tank counterclockwise to reduce airflow and counterclockwise to increase it.

General settings

Menu switching

When the device is turned on, press the main button 3 times in a row to enter the menu mode. Then press the Down button to switch between settings.

Lock / Unlock Resistance, Taste Mode, Output Mode, Version Information, and Memory Mode. Press the main button to enter the submenu.

Resistance setting

When entering the “Resistance Value” submenu, you can make an exact resistance setting by increasing or decreasing it by 0.05 Ohms.

Lock / Unlock Resistance

When entering the “Ω” submenu, switch between the icons to lock / unlock the spiral resistance.

Note

These operations should be carried out at room temperature.

Taste mode

When entering the “Normal” submenu, the display shows: Normal / Soft / Hard / Custom.

User mode

In accordance with personal preferences, users can adjust the preheating of the spiral, setting the output power for the first 10 seconds of soaring. Custom mode is available only in option mode.

Instructions for boxing mod Tesla XT 220W with Tallica Mini tank. Custom mode

Note

Each power adjustment histogram corresponds to 1 second, pressing the Up / Down button adjusts the current power, and pressing the main button proceeds to the next histogram.

After the installation is completed, the prompt “TEST”, “RESET” or “OK” will appear on the screen. You can test the settings first and, if they satisfy you, click the OK button to return to the main screen.

Best Vape Mods, Vape Box Mod, Vape Devices | Ave40

Mode selection

When entering the submenu, pressing the Down button allows you to switch between Kant / SS316 / Ni200 / Ti / TCR modes.

Instructions for boxing mod Tesla XT 220W with Tallica Mini tank. Mode selection

Temperature mode

The temperature control mode screen displays the following information: voltage, output power, temperature, taste control, current mode, battery charge, memory mode M1-M3.

TCR mode

Thanks to the TCR function (temperature coefficient of resistance) with which the device is equipped, you can independently set the value of the helix material for the temperature control mode (SS316 / Ni200 / Ti).

The following is the TCR range for reference.

Material Min value tcr Max TCR
SS316 0.00060 0.00150
Gold 0.00300 0.00350
Ti 0.00350 0.00370
Co 0.00381 0.00390
NiFe 0.00391 0.00550
Ni200 0.00570 0.00700

Version Information

When entering a submenu with a battery icon, the screen displays the following: hardware version, software version, and product model.

Memory mode

When entering the “M” submenu, you can save the current parameter settings in the memory mode M1-M3: power / TCR / temperature / mode / taste mode.

Instructions for boxing mod Tesla XT 220W with Tallica Mini tank. Memory mode

Click Here Ave40  For Vape Wholesale Cooperation.

Now It’s Available: Teslacigs XT 220W Kit
Hot Sale Recommendation:

Vaporesso Aurora Play Zippo Pod Starter Kit

Justfog Compact 14 Starter Kit

Smok Priv N19 Vape Kit

Voopoo Drag Nano Kit

Vaporesso Sky Solo Plus Starter Kit

Vape Wholesale & buy Electronic Cigarettes online in Bulk. Quality Vape Products, Trusted Vape Wholesale Supply by VapeShops Owners.

WHOLESALE INQUIRY: https://www.ave40.com/wholesale-service.html